Sunex-tools SX106B Bedienungsanleitung PDF herunterladen (Seite 2)

SX106B: Parts Breakdown & Operating Manual 2 rev. 12/01/06

FAILURE TO OBSERVE THESE WARNINGS

COULD RESULT IN INJURY

THIS INSTRUCTION MANUAL CONTAINS

IMPORTANT SAFETY INFORMATION.

READ THIS INSTRUCTION MANUAL CAREFULLY

AND UNDERSTAND ALL INFORMATION BEFORE

OPERATING THIS TOOL.

• Always operate, inspect and maintain this

tool in accordance with American National

Standards Institute Safety Code of Portable

Air Tools (ANSI B186.1) and any other

applicable safety codes and regulations.

• For safety, top performance and maximum

durability of parts, operate this tool at 90 psig

6.2 bar max air pressure with 3/8” diameter

air supply hose.

• Always wear impact-resistant eye

and face protection when operating or

performing maintenance on this tool.

Always wear hearing protection when using

this tool.

• High sound levels can cause permanent

hearing loss. Use hearing protection as

recommended by your employer or OSHA

regulation.

• Keep the tool in efficient operating

condition.

• Operators and maintenance personnel must

be physically able to handle the bulk, weight

and power of this tool.

• Air under pressure can cause severe

injury. Never direct air at yourself or others.

Always turn off the air supply, drain hose

of air pressure and detach tool from air

supply before installing, removing or

adjusting any accessory on this tool,

or before performing any maintenance on

this tool. Failure to do so could result

in injury. Whip hoses can cause serious

injury. Always check for damaged, frayed

or loose hoses and fittings, and replace

immediately. Do not use quick detach

couplings at tool. See instructions for correct

set-up.

• Air powered tools can vibrate in

use. Vibration, repetitive motions or

uncomfortable positions over extended

periods of time may be harmful to your

hands and arms. Discontinue use of tool if

discomfort, tingling feeling or pain occurs.

Seek medical advice before resuming use.

• Air powered tools can vibrate in use.

Vibration, repetitive motions or uncomfortable

positions over extended periods of time may

be harmful to your hands and arms.

Discontinue use of tool if discomfort, tingling

feeling or pain occurs. Seek medical advice

before resuming use.

• Place the tool on the work before starting the

tool. Do not point or indulge in any horseplay

with this tool.

• Slipping, tripping and/or falling while

operating air tools can be a major

cause of serious injury or death. Be

aware of excess hose left on the walking or

work surface.

• Keep body working stance balanced and

firm. Do not overreach when operating

the tool.

• Anticipate and be alert for sudden changes

in motion during start up and operation of

any power tool.

• Do not carry tool by the hose. Protect the

hose from sharp objects and heat.

• Tool shaft may continue to rotate briefly

after throttle is released. Avoid direct

contact with accessories during and

after use. Gloves will reduce the risk of cuts

or burns.

• Keep away from rotating end of tool.

Do not wear jewelry or loose clothing.

Secure long hair. Scalping can occur

if hair is not kept away from tool and

accessories. Choking can occur if

neckwear is not kept away from tool

and accessories.

• Do not lubricate tools with flammable or

volatile liquids such as kerosene, diesel or

jet fuel.

• Do not force tool beyond its rated capacity.

• Do not remove any labels. Replace

any damaged labels.

• Use accessories recommended by

Sunex Tools.

1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare